Home > News > Cross-linked heat shrinkable power cord head-type production process of the indoor terminal

News

Cross-linked heat shrinkable power cord head-type production process of the indoor terminal
2011-09-04 22:10:00
 

Cross-linked heat shrinkable power cord head-type production process of the indoor terminal

(1) preparation phase: heat shrinkable power cord accessories checks are complete, whether the match type, moisture check and confirm whether the cord, check the power cord. (2) removal of excess power cord, cord length determined according to the site.
(3) stripped of the power cord sheath.
(4) welding a ground wire, welded steel on the ground.
(5) Sanchakou and around the bag filled sealant.
(6) Installation of three core branches of jacket, the jacket sleeve into the roots starts to shrink from the middle, first to the roots, and then further refers to the department.
(7) stripping copper and the outer semi-conductive layer, stripping the branch sets of three-core copper mouth more than 20mm, non-injury primary insulation, cleaned semi-conductive layer. (8) installation stress pipe, nozzle side part of the support sleeve shrink after docking.
(9) install terminals.
(10) to install insulation tube.
(11) Mounting Gland.
(12) after the installation of the nuclear phase-phase color tube.


Previous   [Return Home] [Print] [Go Back]   Next

Contact Us

  • Contact Person:

    Gavi Chen
  • Tel:

    +86-0574-62166266
  • +86-15888180299
  • Fax:

    +86-574-62179799
  • E-mail:

    gavi@plug9.com

点击这里给我发消息
Click here to send me a message.